What a cedar patio cover costs in Texas
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.

A cedar frame on engineered piers and a roof that ties into the house. Built to keep a Ovilla patio dry in May and shaded in August. About 55 minutes from our Royse City base.
Ovilla is mostly large lots and acreage homes with long backyards and room for an outdoor kitchen. Heritage Park is the town's green space, and Ovilla Road and Westmoreland Road run north toward Cedar Hill and Joe Pool Lake.
City of Ovilla Development Services issues residential permits inside the city. Newer subdivisions have an HOA whose approval comes first. Outside city limits, Ellis County has little or no residential permitting.
Blackland clay with heavy seasonal movement. Every post on a pergola or patio cover goes on an engineered pier set below the active zone, and acreage lots need drainage kept clear of the piers.
A slab edge isn't a footing. Every post lands on an engineered pier or a spot the engineer signs off on.
Flashed at the fascia or on a ledger, pitched to match. If the tie-in leaks, nothing else matters.
Gutters and downspouts carry the new roof's water away from the slab, not onto the foundation.
Roofed cedar patio cover, priced off a signed job. Design and permits are one flat line. Concrete and power are only there if you need them.
| What | Includes | Price |
|---|---|---|
| Cedar post-and-beam patio cover | Western Red Cedar post-and-beam frame on engineered piers with concealed standoff bases, doubled perimeter beams, exposed rafters, corbels at every post, standing seam metal roof sloped for drainage, full stain finish. | $119/SF$20,000 minimum |
| Design, engineering and permits | Engineered plan set for a roofed structure, structural detailing of the post anchorage and roof framing, the permit application and the city's permit fees. | $2,200 |
| Reinforced concrete patio | Base preparation, forming, reinforcement, expansion joints, 4 in placement and broom finish. Patios, walkways and pads. | $19/SF$6,000 minimum |
| Outdoor electrical | Dedicated GFCI-protected circuit from the existing panel, trenched and in conduit, ending at two weather-rated outlets. Rough-in and final trim. | $1,450 |
Covers over 300 SF price lower per SF. Run a size in the cost calculator or see the pricing page.
City of Ovilla Development Services issues residential permits inside the city. Newer subdivisions have an HOA whose approval comes first. Outside city limits, Ellis County has little or no residential permitting. A roofed cover is a structure, so plan on it. Our $2,200 design and permit line covers the engineered plans and the city's fees.
$119 per SF with a $20,000 minimum on covers up to 300 SF, plus $2,200 for design and permit. Bigger covers come in lower per SF because the engineering and setup spread over more area. We price those at the visit.
Usually. We tie in at the fascia or run a ledger, flash it, and match the pitch so water sheds off both roofs. If your roofline is too low for a clean tie-in, we build it freestanding a few inches off the house.
Blackland clay with heavy seasonal movement. Every post on a pergola or patio cover goes on an engineered pier set below the active zone, and acreage lots need drainage kept clear of the piers.
Yes. About 55 minutes from our Royse City base. We build patio covers, pergolas and covered outdoor kitchens across Ellis County.
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.
What a patio cover or pergola permit takes in DFW and East Texas. City permits, HOA approval, engineering, inspections, and why Blackland clay sets pier depth.
The real difference between an open cedar pergola and a roofed patio cover in Texas. Shade, rain, heat, permits and what each one costs.
Want shade without a roof? See pergolas in Ovilla.
Or call 469-721-0129.