What a cedar patio cover costs in Texas
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.

A cedar frame on engineered piers and a roof that ties into the house. Built to keep a Mount Pleasant patio dry in May and shaded in August. 1 hour 50 minutes from Royse City.
Dellwood Park is the in-town anchor, and the older neighborhoods fan out from downtown. Lake Tankersley, Lake Bob Sandlin and Lake Cypress Springs to the south are where the lake homes and the bigger backyards are.
City of Mount Pleasant Building and Development handles residential permits inside the city. Outside city limits, Titus County has little or no residential permitting.
Sandy loam over clay. Good drainage near the surface, but the clay below can move, so post footings are sized to the soil found and piered where the clay is shallow.
A slab edge isn't a footing. Every post lands on an engineered pier or a spot the engineer signs off on.
Flashed at the fascia or on a ledger, pitched to match. If the tie-in leaks, nothing else matters.
Gutters and downspouts carry the new roof's water away from the slab, not onto the foundation.
Roofed cedar patio cover, priced off a signed job. Design and permits are one flat line. Concrete and power are only there if you need them.
| What | Includes | Price |
|---|---|---|
| Cedar post-and-beam patio cover | Western Red Cedar post-and-beam frame on engineered piers with concealed standoff bases, doubled perimeter beams, exposed rafters, corbels at every post, standing seam metal roof sloped for drainage, full stain finish. | $119/SF$20,000 minimum |
| Design, engineering and permits | Engineered plan set for a roofed structure, structural detailing of the post anchorage and roof framing, the permit application and the city's permit fees. | $2,200 |
| Reinforced concrete patio | Base preparation, forming, reinforcement, expansion joints, 4 in placement and broom finish. Patios, walkways and pads. | $19/SF$6,000 minimum |
| Outdoor electrical | Dedicated GFCI-protected circuit from the existing panel, trenched and in conduit, ending at two weather-rated outlets. Rough-in and final trim. | $1,450 |
Covers over 300 SF price lower per SF. Run a size in the cost calculator or see the pricing page.
City of Mount Pleasant Building and Development handles residential permits inside the city. Outside city limits, Titus County has little or no residential permitting. A roofed cover is a structure, so plan on it. Our $2,200 design and permit line covers the engineered plans and the city's fees.
$119 per SF with a $20,000 minimum on covers up to 300 SF, plus $2,200 for design and permit. Bigger covers come in lower per SF because the engineering and setup spread over more area. We price those at the visit.
Usually. We tie in at the fascia or run a ledger, flash it, and match the pitch so water sheds off both roofs. If your roofline is too low for a clean tie-in, we build it freestanding a few inches off the house.
Sandy loam over clay. Good drainage near the surface, but the clay below can move, so post footings are sized to the soil found and piered where the clay is shallow.
Yes. 1 hour 50 minutes from Royse City. We build patio covers, pergolas and covered outdoor kitchens across Titus County.
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.
What a patio cover or pergola permit takes in DFW and East Texas. City permits, HOA approval, engineering, inspections, and why Blackland clay sets pier depth.
The real difference between an open cedar pergola and a roofed patio cover in Texas. Shade, rain, heat, permits and what each one costs.
Want shade without a roof? See pergolas in Mount Pleasant.
Or call 469-721-0129.