What a cedar patio cover costs in Texas
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.

A cedar frame on engineered piers and a roof that ties into the house. Built to keep a Coppell patio dry in May and shaded in August. About 50 minutes from our Royse City base.
Riverchase is the golf neighborhood on the south side, and Old Town Coppell holds the city's older center. Andrew Brown Park and the Coppell Nature Park anchor the outdoor side, and Denton Tap Road runs past most of the neighborhoods.
City of Coppell Building Inspections issues residential permits. Most of Coppell is HOA subdivisions, and HOA approval usually comes before the city permit. The city is built out, so county permitting rarely comes up.
Expansive clay, with some creek and river bottom lots near the Elm Fork. Posts go on engineered piers set below the active zone, and low lots need roof water carried away from the piers.
A slab edge isn't a footing. Every post lands on an engineered pier or a spot the engineer signs off on.
Flashed at the fascia or on a ledger, pitched to match. If the tie-in leaks, nothing else matters.
Gutters and downspouts carry the new roof's water away from the slab, not onto the foundation.
Roofed cedar patio cover, priced off a signed job. Design and permits are one flat line. Concrete and power are only there if you need them.
| What | Includes | Price |
|---|---|---|
| Cedar post-and-beam patio cover | Western Red Cedar post-and-beam frame on engineered piers with concealed standoff bases, doubled perimeter beams, exposed rafters, corbels at every post, standing seam metal roof sloped for drainage, full stain finish. | $119/SF$20,000 minimum |
| Design, engineering and permits | Engineered plan set for a roofed structure, structural detailing of the post anchorage and roof framing, the permit application and the city's permit fees. | $2,200 |
| Reinforced concrete patio | Base preparation, forming, reinforcement, expansion joints, 4 in placement and broom finish. Patios, walkways and pads. | $19/SF$6,000 minimum |
| Outdoor electrical | Dedicated GFCI-protected circuit from the existing panel, trenched and in conduit, ending at two weather-rated outlets. Rough-in and final trim. | $1,450 |
Covers over 300 SF price lower per SF. Run a size in the cost calculator or see the pricing page.
City of Coppell Building Inspections issues residential permits. Most of Coppell is HOA subdivisions, and HOA approval usually comes before the city permit. The city is built out, so county permitting rarely comes up. A roofed cover is a structure, so plan on it. Our $2,200 design and permit line covers the engineered plans and the city's fees.
$119 per SF with a $20,000 minimum on covers up to 300 SF, plus $2,200 for design and permit. Bigger covers come in lower per SF because the engineering and setup spread over more area. We price those at the visit.
Usually. We tie in at the fascia or run a ledger, flash it, and match the pitch so water sheds off both roofs. If your roofline is too low for a clean tie-in, we build it freestanding a few inches off the house.
Expansive clay, with some creek and river bottom lots near the Elm Fork. Posts go on engineered piers set below the active zone, and low lots need roof water carried away from the piers.
Yes. About 50 minutes from our Royse City base. We build patio covers, pergolas and covered outdoor kitchens across Dallas County.
Roofed cedar patio cover pricing per square foot in Dallas-Fort Worth and East Texas, from a signed job, with worked examples and what's not included.
What a patio cover or pergola permit takes in DFW and East Texas. City permits, HOA approval, engineering, inspections, and why Blackland clay sets pier depth.
The real difference between an open cedar pergola and a roofed patio cover in Texas. Shade, rain, heat, permits and what each one costs.
Want shade without a roof? See pergolas in Coppell.
Or call 469-721-0129.